JVC DR-MX10SEK Instructions Manual page 114

Setup Menu
FUNCTION SET UP > VIDEO IN/OUT
g MONITOR TYPE
Set in accordance with the TV to be connected.
4:3LB
4:3PS
16:9AUTO
16:9FIX
h F-1 INPUT
Set in accordance with the video connectors to be connected, when using the [F-1] input connectors on the front panel.
VIDEO
S-VIDEO
i L-1 OUTPUT
For setting the output signal of the connector in accordance with the connecting device, when using the SCART connector
[L-1] on the rear panel.
SCART VIDEO
SCART S-VIDEO
SCART RGB
COMPONENT
j L-1 INPUT
For setting the input signal of the connector in accordance with the connecting device, when using the SCART connector [L-1]
on the rear panel as a input connector.
VIDEO
S-VIDEO
k L-2 SELECT
Setting for the SCART connector [L-2] on the rear panel. Mainly for setting the input signals accordingly when connected.
Also, when this unit is turned off, signals of an external tuner can be set to be output from [L-1]. The items that can be set
changes depending on the AL-1 OUTPUTB setting. [
VIDEO/RGB
S-VIDEO/RGB
SAT VIDEO/RGB
DECODER
INITIAL SET UP > TUNER SET
For setting receiving channels. [
INITIAL SET UP > CLOCK SET
For setting the clock. [
H EN
114
(continued)
When connected with a 4:3 TV. (Black strips are added to the top and bottom
when displaying a 16:9 image.)
When connected with a 4:3 TV. (The left and right are cropped off when
displaying a 16:9 image.)
When connected with a wide TV (16:9).
When connected with a TV fixed at 16:9. (This unit automatically adjust the
screen width when displaying a 4:3 image.)
If connecting video signals (yellow connector).
If connecting S-Video signals (black connector).
Outputs video signals.
Outputs S-Video signals.
Outputs RGB signals.
Outputs component video signals. (If connecting to the TV via the component
terminal.)
If connecting video signals.
If connecting S-Video signals.
If connecting video signals.
If connecting S-Video signals.
If connecting video signals with an external tuner.
If connecting a decoder.
P36]
P34]
P29]