Ptz Page - JVC VN-X35U Instructions Manual

Setting Using Internet Explorer
Setting (continued)

PTZ Page

Set the movement for AAuto ReturnB, AZoom LimitB and APreset PositionB.
This page can be used during access using AadminB or AoperatorB..
● First of all, configure the encoding settings.(A Page 39)
● Click [Advanced Settings] to display setting menu.
● Click [PTZ].
● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the current value.
Note:
● This feature can be used when the distribution size pattern setting on the Encoding page is set to A
(MPEG4 only), C (MPEG4 only), D (JPEG only), F, or H. (A Page 39)
Click
A
Auto Return
Mode
Return Time
Test
B
Limit
Zoom Limit
C
Preset Position
Speed
Speed
58
Restores automatically to the state specified under [Mode] when action is
not performed on the manually operated camera over the interval specified
in [Return Time].
For setting the action after Auto Return.
None : Auto Return disabled.
HOME : Returns to the home position.
Auto Patrol: Restores the auto patrol action.
For setting the time interval before restoring the action via Auto return.
[Set values: 1 minutes, 2 minutes, 3 minutes, 5 minutes, 10 minutes,
20 minutes, 30 minutes, 60 minutes]
Click [Execute] to perform a test execution of the preset Auto Return action.
Set maximum value of electronic zoom feature.
[ :
Set values 1 , 2 , 4 , 8 ]
For adjusting the speed of movement to the Preset Position.
This is also applicable to movement to the Preset Position in the Auto Patrol
mode.
[Set values:Moment, Low, Mid, High]
A
B
C