JVC VN-X35U Instructions Manual page 42

Setting Using Internet Explorer
Setting (continued)
Camera Page (continued)
A
Camera ID
B
Monitor Type
C
Black Level
D
Gamma
E
Enhance
Frequency
F
Enhance Level
42
Character strings entered here will be written to the JPEG comment segment
(item name: camera). Refer to the API Guide on the file formats of JPEG.
For selecting the monitor type according to the monitor used to display the
video images. The picture quality varies according to the type of monitor
selected.
Custom : Enables setting of picture quality according to the user's
preference.
LCD1, LCD2:Picture quality setting for LCD monitors. Two
types are available for selection according to the user's
preference.
CRT : Picture quality setting for CRT (cathode-ray tube) monitors.
[Set values: Custom, LCD1, LCD2, CRT]
Memo:
● Select Custom if you want to set the gamma and enhanced bandwidth
values.
For adjusting the black level. Lowering the value darkens the video image.
Increasing the value brightens the image.
[Setting range: 0 to 2]
Memo:
● If the black level is set to "0", this may be too low depending on the
monitoring device, or dark area will become complete black.
● When using MPEG4 images, set to either "1" or "2".
To alter the appearance of dark areas in a video image, adjust the gamma
curve.
Off : Do not perform gamma correction. The entire image appears dull.
-3 to 3 : Perform gamma correction. When this is set to "0", standard gamma
correction is performed. Setting to a smaller value darkens the image,
while increasing the value brightens the image.
[Set values: Off, -3 to 0 to 3]
Memo:
● The set value is fixed when the monitor type is set to ALCD1B, ALCD2B, or ACRTB.
For setting the type of edge enhancement.
Low : Enhances both thick and thin edges.
High : Enhances thin edges.
[Set values: Low, High]
Memo:
● The set value is fixed when the monitor type is set to ALCD1B, ALCD2B, or ACRTB.
For setting the intensity of edge enhancement.
Larger value : Increases the intensity of edge enhancement.
Smaller value : Decreases the intensity of edge enhancement.
[Setting values: -5 to 0 to 5]