Monitor Signal Output Terminal
Connection
Make use of this terminal for camera angle
adjustment during installation or focus
adjustment in the Focus Assist mode. Connect it
to devices such as a video monitor using a video
cable (RCA).
Memo:
● It is convenient to adjust focus using focus
assist mode. (A Page 24)
1
2
AC24V
MONITOR
OUT
SEE INSTRUCTION MANUAL
CAUTION
: NEVER USE
DO NOT CONNECT TO THE TELEPHONE NETWORK
Note:
● A longer cable extension distance causes
signals to be attenuated, image resolution to
deteriorate and noise to increase.
Memo:
● Select the signal system for the monitor
output using the[MONITOR OUT]switch at
the side of this product. (ANTSCB or APALB)
After adjusting the camera angle, set the
switch to AOFFB. After changing the switch
settings, press the [RESET] button to reboot
the camera.
G
2 1
2 1
ALARM
AUDIO
10BASE-T/
100BASE-TX
PoE
AC 24V
AND
AT THE SAME TIME
PUSH
Audio Signal Input/Output
Terminal Connection
Connect the mini jack R3.5 stereo cable.
L ch : Connect to speakers with built-in
amplifier, etc.
R ch : Connect to plug-in power type capacitor
microphone
1
2
G
2 1
2 1
G
AC24V
ALARM
MONITOR
OUT
AUDIO
10BASE-T/
SEE INSTRUCTION MANUAL
100BASE-TX
CAUTION
PoE
AC 24V
: NEVER USE
AND
AT THE SAME TIME
DO NOT CONNECT TO THE TELEPHONE NETWORK
PUSH
Note:
● Make sure that the external microphone is
connected to the R ch and not other
channels. When the microphone jack is
plugged directly into the unit's [AUDIO IN/
OUT] terminal, loud noises can be
distributed to the network.
Line Out
Speakers with
Built-in Amplifier
L ch
Condenser
microphone
R ch
compatible with
plug in power.
19