Side - JVC VN-X35U Instructions Manual

Jvc megapixel ip camera instructions
Hide thumbs Also See for VN-X35U:
Table of Contents

Advertisement

Side

J
[MONITOR OUT] Monitor Output Selection
Switch
Use this switch to select the availability of output
from the N [MONITOR OUT] terminal as well as
the signal system.(A Page 12)
NTSC : Outputs NTSC signals.
OFF
: No output. Select this value when
distributing images to the network.
PAL
: Outputs PAL signals.
[Default setting: OFF]
Note:
● Images are not distributed to the network
when ANTSCB or APALB is selected.
● When the switch is changed, press the K
[RESET] button for less than 2 seconds to
restart.
K
[RESET] Reset Button
This button functions in two different ways
depending on how it is pressed.
● Reset function
Press and release the button for less than two
seconds to restart AVN-X35UB It takes about
one minute for the unit to restart, and the
[RESET]button is disabled during this interval.
● Focus Assist function
Press and hold down for at least two seconds
but less than five seconds.
The L [STATUS] indicator starts blinking in
green color and orange color repeatedly, and
the Focus Assist mode is enabled.
(A Page 24)
You can also perform the same operation on
the viewer.(A Page 93)
J
K
MONITOR OUT
PAL
OFF NTSC
RESET
STATUS
IRIS
M
L
Memo:
Pressing and holding the button for five seconds
or longer enables the service confirmation
mode. The L [STATUS] indicator lights up in
orange color in this mode. Do not press the
button for 5 seconds or longer.
L
[IRIS] Iris Terminal
Use this terminal to connect the DC iris lens.
(Connection with the video iris lens is not
possible.)
(A Page 16)
M
[STATUS] Status Indicator
This status of this product is indicated in green
or orange color.
Starting up: Lights up in orange
Startup complete: Lights up in green
Error: Blinks in orange
Memo:
● The indicator alternates lighting up in green
color and orange color repeatedly when in
the Focus Assist mode. (A Page 24)
● Blinks in green color after reboot when
"Identify Unit" is set to "Blink" (A Page 75).
● You can turn off the indicator after startup is
complete using the [LED State] of Built-in
Viewer. (A Page 75)
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vn-x35ul - network camera

Table of Contents