Cisco 7931G Administration Manual page 70

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option Description
SW Port Speed and duplex of the network port (labeled with "SW" on the
Configuration Cisco Unified IP Phone). Valid values:
•
•
•
•
•
•
If the phone is connected to a switch, configure the port on the switch
to the same speed/duplex as the phone, or configure both to
auto-negotiate.
If you change the setting of this option, you must change the PC Port
Configuration option to the same setting.
PC Port Speed and duplex of the access port (labeled with "PC" on the Cisco
Configuration Unified IP Phone). Valid values:
•
•
•
•
•
•
If the phone is connected to a switch, configure the port on the switch
to the same speed/duplex as the phone, or configure both to
auto-negotiate.
If you change the setting of this option, you must change the SW Port
Configuration option to the same setting.
PC VLAN Allows the phone to interoperate with 3rd party switches that do not
support a voice VLAN. The Admin VLAN ID option must be set
before you can change this option.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
4-8
Auto Negotiate
10 Half—10-BaseT/half duplex
10 Full—10-BaseT/full duplex
100 Half—100-BaseT/half duplex
100 Full—100-BaseT/full duplex
1000 Full—1000-BaseT/full duplex
Auto Negotiate
10 Half—10-BaseT/half duplex
10 Full—10-BaseT/full duplex
100 Half—100-BaseT/half duplex
100 Full—100-BaseT/full duplex
1000 Full—1000-BaseT/full duplex
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Unlock network
1.
configuration options.
Scroll to the SW Port
2.
Configuration option and
then press the Edit softkey.
3. Scroll to the setting that you
want and then press the
Select softkey.
Press the Save softkey.
4.
Unlock network
1.
configuration options.
Scroll to the PC Port
2.
Configuration option and
then press the Edit softkey.
3. Scroll to the setting that you
want and then press the
Select softkey.
Press the Save softkey.
4.
Unlock network
1.
configuration options.
Make sure the Admin
2.
VLAN ID option is set.
Scroll to the PC VLAN
3.
option, press the Edit
softkey, and then enter a new
PC VLAN setting.
Press the Validate
4.
softkey and then press
the Save softkey.
OL-20798-01