Cisco 7931G Administration Manual page 152

Status Menu
Procedure for Creating a Test Tone
When measuring echo, make sure you first set the input and output levels to 0 dB gain/attenuation on
the trunk. This is set for the gateway (in Cisco Unified Communications Manager for MGCP) or under
IOS CLI for H.323 or SIP.
Place a call.
Step 1
Once the call is established, press the Help button twice, or press Settings > Status > Call Statistics.
Step 2
The Call Statistics screen and Tone softkey should appear.
Press the Tone softkey.
Step 3
The phone generates a 1004 Hz tone at –15 dBm.
For a good network connection, the tone sounds at the call destination only.
•
For a bad network connection, the phone generating the tone may receive echo from the
•
destination phone.
To stop the tone, end the call.
Step 4
For information on interpreting the results of test tone for volume and echo, see the following document:
http://www.cisco.com/en/US/docs/ios/solutions_docs/voip_solutions/EA_ISD.html
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
7-16
Chapter 7 Viewing Model Information, Status, and Statistics on the Cisco Unified IP Phone
OL-20798-01