Cisco 7931G Administration Manual page 40

Overview of Configuring and Installing Cisco Unified IP Phones
Table 1-8 Checklist for Installing the Cisco Unified IP Phones 7931G (continued)
Task and Purpose
If you are configuring the network settings on the phone for an IPv6 network, you
5.
can set up an IP address for the phone by either using DHCP or manually entering an
IP address.
Using DHCP—To enable DHCP and allow the DHCP server to automatically assign
an IP address to the Cisco Unified IP Phone and direct the phone to a TFTP server,
choose Settings > Network Configuration> IPv6 Configuration and:
To enable DHCPv6,set DHCPv6 Enabled to Yes. DHCPv6 is enabled by default.
•
To use an alternate TFTP server, set IPv6 Alternate TFTP Server to Yes, and
•
enter the IP address for IPv6 TFTP Server 1.
Consult with the network administrator if you need to assign an alternative
Note
TFTP server instead of using the TFTP server assigned by DHCP.
Without DHCP—You must configure the IP address, subnet mask, TFTP server, and
default router locally on the phone; choose Settings > Network Configuration>
IPv6 Configuration:
To disable DHCP and manually set an IP address:
To disable DHCPv6, set DHCPv6 Enabled to No.
a.
Enter the static IP address for phone.
b.
Enter the IPv6 prefix length.
c.
Set IPv6 Alternate TFTP Server to Yes, and enter IP address for IPv6 TFTP
d.
Server 1.
You must also enter the domain name where the phone resides by Choosing Settings
> Network Configuration.
The Cisco Unified IP Phone supports having both IPv4 and an IPv6 address
Note
concurrently. You can configure Cisco Unified CM to support IPv4 addresses
only, IPv6 addresses only, or support both IPv4/IPv6 addresses.
Set up security on the phone.
6.
Provides protection against data tampering threats and identity theft of phones.
Make calls with the Cisco Unified IP Phone.
7.
Verifies that the phone and features work correctly.
Provide information to end users about how to use their phones and how to configure
8.
their phone options.
Ensures that users have adequate information to successfully use their Cisco
Unified IP Phones.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 8.0 (SCCP and SIP)
1-26
Chapter 1 An Overview of the Cisco Unified IP Phone
For More Information
See Configuring Startup Network
Settings, page 3-9.
See Network Configuration
Menu, page 4-6.
See Configuring Security on the
Cisco Unified IP Phone, page
See the Cisco Unified IP Phone
7931G Guide for Cisco Unified
Communications Manager 7.0
or later.
See Appendix C, "Providing
Information to Users Via a
Website."
3-9.
OL-20798-01