Positioning Belt - Pride Mobility JAZZY 1121 Owner's Manual

V . C O M F O R T A D J U S T M E N T S
Power Elevating Seat Operation
If your power chair is equipped with a power elevating seat, you can change the seat height either through the
controller or through a toggle switch mounted to one of the armrests.
NOTE: For information on how to raise and lower your seat through the controller, contact your authorised
Pride Dealer.
To operate the toggle switch:
1. Push the toggle switch forward to raise the seat.
2. Pull back on the toggle switch to lower the seat.
The power elevating seat system has an upper and a lower limit of travel. Once the actuator reaches either one of
these limits, you should continue to hear and/or feel the actuator motor running. This is because there is a clutch
mechanism that allows the motor to continue running after the actuator has reached its limit. This clutch works
at both the top and bottom extensions of the lift.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit.
The power elevating seat is equipped with a swivel feature that allows the seat to be turned 90 degrees to which-
ever side the joystick is located.
To use the swivel feature:
1. Locate the friction lock lever under the seat. See figure 12a.
2. Pull back on the friction lock lever and rotate the seat 90° to whichever side the controller is located.
3. Push the friction lock lever forward to lock the seat in place.
WARNING! Do not attempt to drive the power chair with the seat facing to the side. Always
return the seat to the forward facing position before operating the power chair.

Positioning Belt

Your power chair may be equipped with a positioning
belt that can be adjusted for operator comfort. See fig-
ure 29 and 30. The positioning belt is designed to sup-
port the operator so that he/she does not slide down or
forward in the seat. The positioning belt is not designed
for use as a restraining device.
WARNING! The positioning belt should
be secured at all times. Never allow
the positioning belt to hang or drag on
the floor as it may become entangled.
To install the positioning belt on a Contour Seat:
1. Remove the rearmost screw that holds the seat
hinge to the seat base on both the left and right seat
hinges.
2. Insert the screw through the supplied washer,
through the positioning belt and into the seat base
for each side of the power chair seat.
3. Tighten both screws.
30
Figure 29. Positioning Belt Attachment on a Contour
Seat
www.pridemobility.com Jazzy 1121