Pride Mobility JAZZY 1121 Owner's Manual page 18

Euro Seat Installation
The Euro Seat is attached to the power base by four seat towers. Each tower is inserted into a receiver on the power
base frame. The seat towers have holes that enable you to adjust the seat height. Ball detent pins are inserted
through the receiver and through the seat towers to secure the seat
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot and you may
lose control of the seat if they do so.
To install the Euro Seat:
1. Lift the seat over the power base.
2. Align each seat tower with the corresponding receiver. See figure 11.
3. Gently allow the seat to slide into each receiver until the seat is at the desired height.
4. Insert the retaining clips into each receiver.
5. Install the armrests (if necessary).
6. Loosen the setscrews on the controller mount.
MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the
outside of the armrest pad. Route the harness under the armrest or toward the inside of the
armrest pad. Use correct tie-down points for the controller harness to prevent the harness from
getting caught in the drive tyres, pinched in the seat frame, or damaged when passing through
doorways.
7. Slide the controller into the armrest.
8. Tighten the setscrews to secure the controller.
9. Use a wire tie to secure the controller harness to the armrest.
10. Plug the controller harness into the connector on the power base.
SEAT TOWER
SEAT
RECEIVER
Figure 11. Euro Seat Installation/Removal
18
I V . A S S E M B L Y
RETAINING CLIP
www.pridemobility.com
CONTROLLER
MOUNT
POWER
BASE
Jazzy 1121