Pride Mobility JAZZY 1121 Owner's Manual page 27

V . C O M F O R T A D J U S T M E N T S
To change the controller position:
1. Turn off the power to the controller.
2. Disconnect the controller connector(s) from the
electronics tray.
3. Cut the wire tie that attaches the controller harness
to the armrest.
4. Flip the armrests up so they are perpendicular to the
floor.
5. Loosen the setscrew on the underside of each arm-
rest. See figure 24.
6. Slide the controller out of the armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrews.
9. Use a wire tie to secure the controller harness to the
armrest. See figure 13.
10. Plug the controller connector(s) into the electronics
tray.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to one of six
different heights in 2.54 cm (1 in.) increments.
To raise or lower the foot platform:
1. Remove the nuts and bolts from the foot platform
bracket. See figure 25.
2. Raise or lower the foot platform to the desired
height.
3. Reinstall the bolts and nuts into the foot platform
bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the nuts and bolts from the foot platform
bracket. See figure 25.
2. Move the foot platform in or out to the desired
depth.
3. Reinstall the nuts and bolts into the foot platform
bracket and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform with a hex
key. See figure 26.
To adjust the foot platform angle:
1. Locate the setscrew on the underside of the foot
platform.
2. Turn the setscrew to raise or lower the front of the
foot platform.
Jazzy 1121
BALL DETENT PIN
Figure 25. Foot Platform Adjustment
SETSCREW
Figure 26. Foot Platform Angle Adjustment
www.pridemobility.com
FOOT PLATFORM BRACKET
NUTS AND BOLTS
27