Pride Mobility JAZZY 1121 Owner's Manual page 25

V . C O M F O R T A D J U S T M E N T S
Seat Position Adjustment
You can move the seat forward or rearward by chang-
ing the extrusion mounting position.
To change the seat position:
1. Turn off the power to the controller.
2. Disconnect the controller from the power base.
3. Remove the seat.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of
mounting holes. See figure 22. You must move
both extrusions the same number of holes either
forward or rearward.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Reconnect the controller to the power base.
Manual Recline Adjustment
If your power chair is equipped with a reclining seat,
you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of
the seat base.
To adjust the seatback angle on a contour seat:
1. Pull up on the seatback release lever.
2. Set the seatback at the desired angle by leaning for-
ward or back.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seat-
back, you can adjust it to four (4) different angles: 90°,
102°, 105° or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws on both seat hinges.
See figure 23.
2. Set the seatback at the desired angle.
3. Reinstall the screws on both seat hinges and tighten.
Jazzy 1121
Figure 22. Universal Mounting System
JAM NUT
ARMREST ANGLE
ADJUSTING SCREW
ARMREST
HEIGHT
ADJUSTING
SETSCREWS
SEATBACK ANGLE
ADJUSTING
SCREW
ARMREST
KNOB
Figure 23. Seatback Angle Adjustment
www.pridemobility.com 25