Footrest Angle; Footrest Height; Positioning Belt - Pride Mobility Jet 7 Owner's Manual

6. Place the joystick mounting bracket in the other armrest.
7. Tighten the setscrew in each armrest.
8. Connect the controller cable to the armrest with a new
tie-wrap. See figure 14.

FOOTREST ANGLE

You can adjust the angle of the footrest with a 5-mm hex span-
ner. See figure 15.
To adjust the footrest angle:
1. Turn the setscrew clockwise to lower the front of the footrest.
2. Turn the setscrew anticlockwise to raise the front of
the footrest.

FOOTREST HEIGHT

The footrest height is easily adjusted to any one of six different
heights. See figure 15.
To raise or lower the footrest:
1. Remove the height adjustment bolt from the footrest using
a 6-mm hex key and 13-mm socket. See figure 15.
2. Raise or lower the footrest to the desired height.
3. Reinstall the bolt into the footrest.

POSITIONING BELT

Your power chair seat may be equipped with an adjustable, auto-
type positioning belt. The positioning belt is designed to support
you so you do not slide down or forward in the seat. The posi-
tioning belt is not designed for use as a restraining device.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to the
seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through the
positioning belt, and into the seat base for each side.
3. Tighten both screws.
To adjust the positioning belt:
1. When seated, insert the metal tab on the right side of the belt
into the plastic housing on the opposite strap until you hear a
click.
2. Pull the strap on the right side of the belt until it is secure
but not so tight as to cause discomfort.
WARNING! Although your power chair may be
equipped with a positioning belt, this belt is not
designed to provide proper restraint during
motor vehicle transport. Anyone traveling in a
motor vehicle should be properly secured in
the motor vehicle seat with safety belts securely
fastened. Do not sit on your power chair while
it is in a moving vehicle. Personal injury and/or
property damage may result.
JET7/REV A/OCTOBER 2002
CONTROLLER MOUNTING
BRACKET
LOOSEN THIS SETSCREW
TO ADJUST THE
CONTROLLER.
Figure 13. Controller Extension
USE A TIE-WRAP TO
SUPPORT THE
CONTROLLER CABLE.
Figure 14. Controller Installation
FOOTREST HEIGHT
ADJUSTMENT
FOOTREST ANGLE
ADJUSTMENT (SETSCREW
LOCATED UNDERNEATH
FOOTREST)
Figure 15. Footrest Adjustment
WWW.PRIDEMOBILITY.COM
15