Pride Mobility JAZZY 1121 Owner's Manual page 24

V . C O M F O R T A D J U S T M E N T S
Contour Seat Height and Angle Adjustment
The seat is connected to the power base via the UMS.
You can change the seat height by raising or lowering
the front and rear trapeze bars. If you raise or lower
only one trapeze bar (front or rear), you can also change
the seat base angle. If your power chair is equipped
with a power elevating seat, then you change the seat
height through the controller or a switch.
To change the seat height or seat angle:
1. Turn off the power to the controller.
2. Disconnect the controller from the power base.
3. Flip up the seat latch safety. See figure 20.
4. Squeeze the seat latch and release the seat from the
front trapeze bar.
5. Slide the seat forward and remove it from the
power base.
6. Loosen the screws that attach the trapeze bars to the
seat towers. See figure 21.
7. Remove the retaining clips that secure the seat tow-
ers to the power base.
8. Move the trapeze bars up or down to the desired
height.
NOTE: Change the seat dump by raising or lowering
only one trapeze bar (front or rear).
9. Reinstall the retaining clips from step 7.
10. Remove each screw from the trapeze bars and
apply thread lock.
11. Reinstall each screw into the trapeze bars and
tighten.
12. Reinstall the seat.
13. Reconnect the controller to the power base.
24
Figure 20. Seat Latch Safety
RETAINING CLIPS
Figure 21. Trapeze Bar Adjustment
www.pridemobility.com
SCREWS
RETAINING
CLIPS
Jazzy 1121