Pride Mobility JAZZY 1121 Owner's Manual page 28

V . C O M F O R T A D J U S T M E N T S
Anti-Tip Wheels
The anti-tip wheels are designed to give your power
chair increased stability on rough surfaces. The anti-tip
wheels are preset at the factory for smooth surfaces or
indoor use only. If you plan on using your power chair
on rough surfaces, it may be necessary to adjust the
anti-tip wheels to better suit your needs. The anti-tip
wheels may need adjustment if either of the following
occur:
When coming to a stop, your power chair tips for-
ward excessively.
The anti-tip wheels constantly rub the ground.
NOTE: Each drive tyre must be inflated to the psi/
bar/kPa air pressure rating indicated on the tyre in
order for the anti-tip wheels to be properly adjusted.
WARNING! Consult your authorised
Pride Dealer before attempting to
change the
Changing the anti-tip wheel height
affects handling under deceleration!
WARNING! The higher you raise the
anti-tip wheels, the more you increase
your power chair's
forward when coming to a stop. You
can compensate for this by having your
authorised Pride Dealer make a small
adjustment to the pre-programmed
deceleration setting in the controller
or by moving the seat assembly further
to the rear of your power chair.
PROHIBITED! Do not remove the anti-
tip wheels.
To adjust the anti-tip wheels:
1. Remove the anti-tip wheel. See figure 27.
2. Remove the nut and bolt on the anti-tip bracket.
3. Raise or lower the anti-tip bracket.
4. Reinstall the nut and bolt on the anti-tip bracket.
5. Reinstall the anti-tip wheel.
6. Raise or lower the other anti-tip bracket so that it is
at the same height.
28
anti-tip wheel height!
tendency to tilt
www.pridemobility.com
ANTI-TIP WHEEL BRACKET
ANTI-TIP WHEEL
Figure 27. Anti-Tip Wheel Assembly
Jazzy 1121