Comfort Adjustments - Pride Mobility JAZZY 1121 Owner's Manual

V . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your power chair's operation, you may find the need to make some adjustments to
increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle and the
controller's position. If your power chair is equipped with a Synergy Seat, refer to the information provided in
separate manuals.
WARNING! The centre of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your authorised Pride Dealer has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products Ltd. or your
authorised Pride Dealer.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort adjustments:
metric/standard hex key set
metric/standard socket set and ratchet
adjustable spanner
Euro Seat Height and Angle Adjustment
There are four steel towers that connect the seat to the power base. You can change the seat height by raising the
seat towers. If you raise or lower only one set of seat towers (front or rear), you can also change the seat base
angle. If your power chair is equipped with a power elevating seat, then you change the seat height through the
controller or a switch.
To change the seat height or seat angle:
1. Remove the retaining clip from each of the four seat
towers. See figure 11.
2. Raise or lower each seat tower to the desired posi-
tion. To change the angle, set either the front or rear
seat towers higher or lower than the other.
3. Reinstall the retaining clip into each seat tower.
Euro Seat Manual Recline Adjustment
If your power chair is equipped with a reclining seat,
you can adjust the seatback angle with the manual
recline lever.
To adjust the seatback angle:
1. With your back pressed firmly against the seatback,
squeeze the manual recline lever mounted to the
armrest. See figure 14.
2. Set the seatback at the desired angle by leaning for-
ward or back.
3. Release the manual recline lever when the seatback
is at the desired angle.
Jazzy 1121
Figure 14. Manual Recline Seatback Adjustment
www.pridemobility.com
MANUAL RECLINE
LEVER
21