Pride Mobility JAZZY 1121 Owner's Manual page 26

V . C O M F O R T A D J U S T M E N T S
Armrest Width Adjustment
You can change each armrest's width independently of
each other.
NOTE: Changing the armrest width may increase the
overall width of your power chair.
To change the armrest width:
1. Locate the two armrest knobs on each side of the
armrest receiver bracket. See figure 23.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicu-
lar to the floor.
2. Loosen the locking nut. See figure 23.
3. Loosen the adjusting screw.
4. Turn the adjusting screw to raise or lower the front
of the armrest.
5. Tighten the locking nut to secure the adjusting
screw into place.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest
receiver.
2. Raise or lower the armrest to the desired height. See
figure 23.
3. Tighten the setscrews to secure the armrest.
Controller Position Adjustment
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 24.
3. Slide the controller into or out of the armrest to the
desired position.
26
Figure 24. Underside of Armrest
www.pridemobility.com
CONTROLLER BRACKET
SETSCREW
Jazzy 1121