Preparing A Device For Remote Management - Honeywell MX7 Tecton Reference Manual

Preparing a Device for Remote Management

Two additional utilities are necessary for remote management.
The Remote Management Utility (RMU) must be installed on all mobile devices first – then you can control mobile
l
device reboot, storage RAM adjustment, real-time updates and Avalanche Enabler properties. If the RMU is not already
installed on the MX7 Tecton, see
If in doubt, verify RMU.CE.CAB exists in the \System folder. If the RMU.CE.CAB file is present when the Enabler is
installed, the RMU is also installed.
Important: If the OS package includes double-byte Asian fonts, the storage RAM property of the RMU must be higher
than the default value (40MB).
If the amount of storage RAM is too low, the Enabler returns a "Mobile unit out of resources" error.
To determine the minimum value required, inspect the RMU.StorageRAM>=nn parameter in the Criteria field for the OS
package. Generally, this setting should be approximately 40 MB above the amount of RAM in use on the device for a
standard OS and 50MB above the amount of RAM in use for an OS with Asian fonts.
For example, if after installing all the software, the device shows 5MB in use, this setting should be about 45MB for a
standard OS, 55 MB for an Asian OS.
Use the Wireless Configuration Application (WCA) when you want to remotely manage the Cisco client or Summit
l
client device. This utility is downloaded and installed in addition to the Remote Management Utility. The WCA is
included when the Summit or Cisco radio driver software is updated. The WCA is automatically installed when the radio
driver is updated.
If the Remote Management Utility (RMU) is not present on the MX7 Tecton, see
System Baseline.
Using Wavelink Avalanche to Upgrade System Baseline.
Using Wavelink Avalanche to Upgrade
7-5