Enable Code Id; Buttons - Honeywell MX7 Tecton Reference Manual

Enable Code ID

Choose an option in the Enable Code ID drop-down box:
None
AIM ID
Honeywell ID
Symbol ID
HHP ID
Custom ID

Buttons

Symbology Settings
Ctrl Char Mapping
Custom Identifiers
HHP Properties
See Also: "Data Processing Overview"
4-88
Disables transmission of a Code ID. The only entry in the Symbology combo box is All.
Transmits the AIM ID with each bar code. The combo box in the Symbology panel is populated with
the known AIM ID symbologies for the scan engine in focus, plus any configured Custom code IDs.
Transmits the Honeywell ID with each bar code. The combo box in the Symbology panel is pop-
ulated with the known Honeywell symbologies for the Honeywell laser scanner, plus any configured
Custom code IDs.
Transmits the Symbol ID with each bar code. The combo box in the Symbology panel is populated
with the known Symbol ID symbologies for the Symbol laser scanner, plus any configured Custom
code IDs.
The imager always transmits the HHP ID with each bar code, so the Code ID is used to identify the
bar code being processed. The combo box in the Symbology control panel is populated with the
known HHP ID symbologies for that platform, plus any configured Custom code IDs.
Does not change the scanner's Code ID transmission setting. The combo box in the Symbology con-
trol panel is populated with any configured Custom code IDs.
Individually enable or disable a bar code from being scanned, set the mini-
mum and maximum size bar code to accept, strip Code ID, strip data from
the beginning or end of a bar code, or (based on configurable Barcode
Data) add a prefix or suffix to a bar code before transmission.
Define the operations the Data Collection Wedge performs on control char-
acters (values less than 0x20) embedded in bar codes.
Defines an identifier that is at the beginning of bar code data which acts as
a Code ID. After a Custom Identifier is defined, Symbology Settings can
be defined for the identifier just like standard Code IDs.
HHP Properties allows Hand Held Products Imager global (not symbology
specific) parameters to be configured. This button is only visible when a
Hand Held Products 5300 imager is installed in the MX7 Tecton.