Honeywell MX7 Tecton Reference Manual page 105

Option
Report failure to reconnect
Clear Pairing Table on Boot
Auto Reconnect on Boot
Auto Reconnect
Function
This option is Enabled (checked) by default.
The default time delay is 30 minutes. This value cannot be changed by the user.
There may be an audio or visual signal when a connection between a paired, active device fails
to re-connect. A visual signal may be a dialog box placed on the display notifying the user the
connection between one (or all) of the previously paired Bluetooth devices has failed.
Tap the X button or ok button to close the dialog box.
Possible reasons for failure to reconnect: Timeout expired without reconnecting; attempted to
pair with a device that is currently paired with another device; attempted to pair with a known
device that moved out of range or was turned off; attempted to pair with a known device but the
reason why reconnect failed is unknown.
This option is Disabled (unchecked) by default.
When enabled (checked), all previous paired information is deleted upon any reboot sequence
and no devices are reconnected.
When enabled (checked) "Auto Reconnect on Boot" is automatically disabled (dimmed).
This option is Enabled (checked) by default. All previously paired devices are reconnected
upon any reboot sequence.
When disabled (unchecked), no devices are reconnected upon any reboot sequence.
This option is Enabled (checked) by default. This option controls the overall mobile Bluetooth
device reconnect behavior.
When Auto Reconnect is disabled (unchecked), Auto Reconnect on Boot is
l
automatically disabled and dimmed.
When Auto Reconnect is disabled (unchecked), no devices are reconnected in any
l
situation. The status of Auto Reconnect on Boot is ignored and no devices are
reconnected on boot. The status of Clear Pairing Table on Boot controls whether the
pairing table is populated on boot.
When Auto Reconnect is enabled (checked) and Auto Reconnect on Boot is disabled
l
(unchecked), devices are not reconnected on boot, but are reconnected in other
situations (example: return from out-of-range).
When Auto Reconnect is enabled (checked) and Clear Pairing Table on Boot is enabled
l
(checked), devices are not reconnected on boot, but are reconnected in other situations
(example: return from out-of-range). The pairing table is cleared on boot. The status of
Auto Reconnect on Boot is ignored and the option is automatically disabled (unchecked)
and dimmed.
4-67