Sensor In Use Display - Furuno NAVpilot-700 Operator's Manual

5.6

Sensor in Use Display

The SENSOR IN USE display provides a comprehensive list of the sensors connected
to your NAVPILOT.
1. In the STBY mode, press the MENU key to show the STBY mode menu.
MESSAGE
SENSOR IN USE
SEA STATE: FULL-AUTO
MANUAL PARAMETER
ADVANCED AUTO:
OTHER MENU
NAVpilot-700
2. Rotate the Course control knob to select [SENSOR IN USE] then push the knob.
The display shows the source for each data and the equipment identifier number. For
example the source of HDG is the FURUNO PG-700 and its equipment identifier num-
ber is 0019E4. Dashed lines indicate no connection or sensor is not currently active.
MESSAGE
SENSOR IN USE
CONTRAST/BRILLIANCE
SEA STATE: FULL-AUTO
ON MANUAL PARAMETER
SENSOR IN USE
HDG : PG-700 : 0019E4
STW : PORT1
SOG : NAVNET3 : 000C2F
POS : NAVNET3 : 000C2F
WIND : --------------
DPT : --------------
TEMP: --------------
5. MAINTENANCE, TROUBLESHOOTING
NAVpilot-711/720
5-11