Furuno NAVpilot-700 Operator's Manual page 59

4. Use the Course control knob to select [ON] then push the knob.
When this is done the menu items for power assist appear.
SAFE HELM/P.ASSIST SETUP
SAFE HELM:
SAFE HELM RESPONSE
POWER ASSIST: OFF
POWER ASSIST STBY: ON
POWER ASSIST RUDDER SPEED
5. Use the Course control knob to select [FOR SPEEDS UNDER] then push the
knob.
6. Rotate the Course control knob to set the highest speed at which power assist
activates. The setting range is 1.0 to 9.9 knots.
7. If you want power assist in the STBY mode, use the Course control knob to
set [POWER ASSIST STBY] to [ON].
8. Use the Course control knob to select [POWER ASSIST RUDDER SPEED] then
push the knob.
9.
POWER ASSIST RUDDER SPEED
RUDDER SPEED:
TURN HELM PORT/STBD TO
SET RUDDER SPEED.
HIGHER VALUE = FASTER SPEED
PUSH MENU KEY TO CONTINUE
10. Turn the helm to port and starboard to set safe helm response time then push the
Course Control knob.
11. Press the MENU key to finish.
ON
RETURN DELAY 5 SEC
FOR SPEEDS UNDER 3.0kn
10
20 10 5 5 10 20
2. STEERING MODES
2-35