Furuno NAVpilot-700 Operator's Manual page 92

5. MAINTENANCE, TROUBLESHOOTING
Error
no.
0011 "BYPASS/CLUTCH IS SHORT-
ED OUT"
0013 "RUDDER DRIVE ERROR"
0017 "RUDDER ANGLE ERROR"
0301 "COMMUNICATION ERROR"
Notice
2001 "INPUT VOLTAGE IS UNDER
LIMIT"
2003 "INPUT VOLTAGE IS OVER
LIMIT"
2101 "NAV MODE PARAMETER ER-
ROR"
2105 "START TO TURN BY FISHING
MODE"
2107 "CIRCLE MODE STOPPED"
2109 "MODE WAS CHANGED"
2201 "WARNING. REMOTE CON-
TROLLER'S SW IS ON"
2203 "THE PRESET TIME SET HAS
PASSED"
2301 "HEADING SOURCE ARE
CHANGED"
2303 "WIND SOURCE ARE
CHANGED"
2305 "POSITION SOURCE ARE
CHANGED"
2307 "SPEED SOURCE HAS
CHANGED"
2330 "ARRIVED AT LAST WAY-
POINT"
2340 "WAYPOINT WAS CHANGED"
2360 "NO WATER TEMP DATA"
2362 "NO DEPTH DATA"
2370 "HELM SENSOR ERROR"
2901 "NO COMPASS ADJUSTMENT
DATA"
5-10
Error message Meaning, remedy
Bypass/clutch is shorted. Turn off power.
Turn off power.
Turn off power.
No communication between processor
unit and all control units. Turn off power.
Input voltage under limit. Check power
supply.
Input voltage over limit. Check power sup-
ply.
Invalid parameter entered in NAV mode.
Reenter parameter.
Boat is starting to turn after dodge opera-
tion.
Circle mode was stopped.
Steering mode changed.
Remote controller switch is ON. Turn it
OFF to continue operation.
Watch alarm has activated.
Heading source changed.
Wind source changed.
Position source changed.
Source of speed changed.
Arrival alarm alerts you to arrival at final
waypoint.
Switching to next waypoint.
Check water temperature sensor.
Check depth sensor.
Check helm sensor.
Check heading sensor.