How To Turn Power On, Off - Furuno NAVpilot-700 Operator's Manual

1.2

How to Turn Power On, Off

Control unit
FAP-7001
FAP-7011
FAP-7021
*:A timer counts down the time that remains until the power goes off
When the heading sensor PG-500 (or PG-700) is connected, see the note at the bot-
tom of this page. A beep sounds and the equipment shows product information fol-
lowed by the results of the startup test. The start up test checks the ROM, RAM and
backup of the processor unit and control unit. The test also checks for the presence of
heading from the heading sensor and rudder angle information from the rudder refer-
ence unit.
AUTO PILOT
NAVPILOT-700*
FURUNO ELECTRIC CO., LTD
* Or NAVPILOT-711, NAVPILOT-720
If NG appears for any item, an error message, shown in the table below, appears. Fol-
low the information provided in the message to restore normal operation. If you cannot
restore normal operation, contact your dealer for information.
BACK UP DATA IS BROKEN. USE FACTORY DE-
FAULT. PUSH ANY KEY TO CONTINUE.
CAN NOT RECEIVE HEADING DATA. PLEASE
CHECK THE HEADING SENSOR. PUSH ANY KEY TO
CONTINUE.
Note: When the Heading Sensor PG-500/PG-700 is connected, turn on the NAVpilot
and wait four minutes before you leave port. This allows time for the PG-500/PG-700
heading data to stabilize.
Key
POWER/BRILL Short-press
POWER/STBY Short-press
STBY/POWER Short-press
START UP TEST
PROCESSOR
CONTROLLER
PROCESSOR UNIT OK
CONTROLLER
HEADING SENSOR
RRU
CONTROLLER ID 1
**.** : Program version no.
Error message
ON OFF
Long-press*
Long-press*
Long-press*
6454007-**.**
6454011-**.**
ROM RAM
OK
OK OK
OK
-------------------------------------------
OK
Backup data is corrupted.
Problem with heading
sensor.
1. INTRODUCTION
BACKUP
OK
OK
359.9°
P12.3°
Meaning
1-3