Furuno NAVpilot-700 Operator's Manual page 91

Error
Error message
no.
5305 "APP WIND SPEED ALARM"
5307 "SPEED ALARM"
5309 "WATER TEMP ALARM"
5311 "DEPTH ALARM"
5313 "TRIP ALARM"
Error
1101 "TOO FAST TO GO FISHING
MODE. PLEASE SLOW DOWN
LESS THAN 10 kn."
1201 "COMMUNICATION ERROR"
1203 "FU REMOTE CONTROLLER
ERROR"
1301 "MISSING HEADING DATA"
1303 "HEADING DATA IS SHIFTED"
1305 "NO SPEED DATA"
1307 "NO WIND DATA"
1309 "WIND DATA IS SHIFTED"
1311 "NO NAV DATA. WAIT FOR 1
SECONDS."
1315 "DEGRADATION OF NAV DATA
QUALITY"
1317 "NO POSITION DATA"
1901 "RATE SENSOR ERROR"
1903 "BACKUP ERROR"
Fail
0001 "DRIVE UNIT ERROR"
0003 "DRIVE UNIT OVERLOAD"
0005 "DRIVE UNIT IS OVER- HEAT-
ED"
0007 "BYPASS/CLUTCH DRIVE
ERROR"
0009 "BYPASS/CLUTCH IS
OVERLOADED"
5. MAINTENANCE, TROUBLESHOOTING
Meaning, remedy
Apparent wind alarm violated (sailboats
only).
Speed alarm violated.
Water temperature alarm violated.
Depth alarm violated.
Your boat has travelled the distance set
for the trip alarm.
Set speed below 10 knots then go to re-
spective mode.
No communication between processor
unit and control unit. Turn off power.
Check remote controller.
Check heading sensor.
Heading data has changed abruptly.
Check heading sensor.
Check speed sensor.
Check wind sensor.
Wind data has changed abruptly. Check
wind sensor.
Check nav data sensor.
Check nav data sensor.
Check position-fixing equipment.
Check rate sensor.
All user and engineer default settings are
restored. Reenter installation settings.
Turn off power
Turn off power.
Temperature of drive circuit is higher than
80°C(176°F). Turn off power.
Bypass/clutch error. Turn off power.
Bypass/clutch overload. Turn off power.
5-9