Entering Mwi For Cisco Callmanager - Cisco DPA 7630 Administration Manual

Configuring Cisco CallManager Settings
Step 1
Step 2
Step 3
Step 4
Step 5

Entering MWI for Cisco CallManager

Step 1
Step 2
Step 3
Step 4
Step 5
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
6-10
To assign a TFTP server, perform these steps:
From the main menu, choose Configure.
Choose CallManager.
Choose TFTP server address.
Enter the IP address or domain name of the TFTP server.
To enter multiple TFTP servers, separate them using a comma (,) or semicolon (;).
You can enter a maximum of five (5) TFTP servers.
Restart the DPA 7630/7610.
On Cisco CallManager, you must set the dialing sequence used to enable and
disable the MWI on phones connected to Cisco CallManager. These settings must
match those entered in Cisco CallManager (see the
Waiting Light" section on page
To enter the MWI settings, perform these steps:
From the main menu, choose Configure.
Choose CallManager.
Choose the appropriate settings:
CallManager MWI ON directory number
•
• CallManager MWI OFF directory number
Enter the appropriate values obtained from the Cisco CallManager system.
Restart the DPA 7630/7610.
Chapter 6
"Configuring the Message
4-13).
Configuring Telephony Settings
78-11069-03