Configuring Network Settings; Setting The Host Name - Cisco DPA 7630 Administration Manual

Configuring Network Settings

Configuring Network Settings

Setting the Host Name

Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
5-4
Figure 5-1 DPA 7630/7610 Main Menu
You must configure the network settings on the DPA 7630/7610 to connect it to
the IP network. After configuring any network settings, you must restart the
DPA 7630/7610. See the
The host name is the device name sent to the Cisco CallManager server (with the
port number appended to it) when the DPA 7630/7610 registers its ports with
Cisco CallManager. It appears in the MAC address field. See the
DPA 7630/7610 to Cisco CallManager" section on page 4-3
Typically, to ensure that the DPA 7630/7610 registers properly with
Cisco CallManager, you should not change the host name. However, you might
need to change it in some special situations.
Chapter 5
"Restarting the DPA 7630/7610" section on page
Getting Started with the DPA 7630/7610
"Adding the
for details.
78-11069-03
7-1.