Verifying Installation - Cisco DPA 7630 Administration Manual

Verifying Installation

Verifying Installation
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
3-18
After you complete installation of the DPA 7630/7610 and have connected power
to it, connect a console terminal to observe its initial startup procedure. You can
only observe these initial startup messages when connected to the console port.
Initially, the device uses DHCP by default, but you can reconfigure this after
startup.
The startup process proceeds as follows:
Loads boot loader software image and starts up the DPA 7630/7610.
1.
Performs self tests on the hardware, indicating whether the component
2.
passed; for example:
Testing RAM......passed
Testing FLASH....passed
Testing EEPROM...passed
Testing Ethernet..passed
3. Pauses for 10 seconds, allowing you to access the boot loader by pressing the
Esc key on the console terminal. The boot loader allows you to do the
following:
• Load a software image using FTP, allowing recovery from a previous
failed upgrade (see
page 7-4).
Load an image using XMODEM
•
• Reset to factory default settings
Loads the main software image and displays the main menu (see
4.
Figure 3-13).
Chapter 3
"Resolving an Incomplete Upgrade" section on
Installing the DPA 7630/7610
78-11069-03