Turning Ais Function Off; Turning Ais Display On/Off - Furuno FCR-2107 Series Operator's Manual

5.2

Turning AIS Function Off

Use the trackball to set the cursor on the AIS status indication in the information area. Long-push the left button to
display FUNC OFF. To activate AIS, push the left button again.
AUTO
MAN
SINGLE
xx.xx xx.xx
Note: You cannot enable AIS if any of the items listed below are active.
Manual speed
Manual set & drift
Speed from reference targets
The message shown right appears if you try to activate the AIS function when the above-mentioned items are active.
5.3

Turning AIS Display On/Off

Targets which are being tracked by an AIS transponder can also be displayed on the display. Put the cursor on the
AIS status indication in the information area then push the left mouse button to select an option :DISP OFF, DISP
FIL, or DISP ALL. DISP FIL filters AIS targets according to the settings on the AIS filter dialog box (see the
procedure below.)
AUTO
MAN
SINGLE
xx.xx xx.xx
5. AIS Operation
5-3