Appendix B. Terminal Mode Commands; General - Comtech EF Data KST-2000B Installation And Operation Manual

Appendix B. TERMINAL MODE
This appendix defines the protocol and command structure for remote control and status
monitoring of the KST-2000A/B in the terminal mode of the Windows™ based M&C
remote control software and on the KP-10 keypad.
B.1

General

The commands for Firmware 10303-1 are listed in this manual. The following table show
evolution of the firmware. Contact Comtech EF Data, Customer Support Department, if
there is a problem or concern regarding the firmware.
Firmware
7084-1
9364-1
10303-1
Remote control and status information are transferred via an EIA-485, EIA-422 or
EIA-232 serial communications link. Commands and data are transferred on the remote
control communications link as ASCII encoded character strings. The remote
communications link is operated in a half duplex mode. Communications on the remote
link are initiated by a remote controller or terminal. The KST-2000A/B never transmits
data on the link unless it is commanded to do so.
•
Firmware number: FW/10303-1D
•
Software version: 1.1.5
Revision Version
K 2.1.1
D 3.1.1
D 1.1.5
B–1
COMMANDS
Remarks
No FSK and Keypad
FSK and No Keypad
FSK and Keypad