Saving And Loading Lens Files; Setting Lens File Data - Sony PMW-300K1 Operating Instructions Manual

Saving and Loading
Lens Files

Setting Lens File Data

Set the data in lens files in "LENS File" in the
setup menu (page 98).
You can set the following data and save it as a
lens file.
Setting data
V modulation shading
compensation values
Center marker position
Flare level
White balance
compensation value
White shading
compensation value
See "Basic Menu Operations" (page 79) for details
on menu operations.
Saving Lens Files
Insert an SxS memory card into a memory card
slot, or connect a USB memory to the USB
connector (type A), then proceed as follows.
See "Basic Menu Operations" (page 79) for
information about menu operations.
1
Select "LENS File" in the setup menu.
2
Select "Store Mem," "Store SxS," or
"Store USB" by using the joystick or the
jog dial, then press the SEL/SET button
or jog dial.
Select "Store Mem" if you want to save the
data in the camcorder's internal memory,
select "Store SxS" if you want to save the
data on an SxS memory card, or select "Store
USB" if you want to save the data on a USB
memory.
130

Saving and Loading Lens Files

Sub-items
M V Modulation
Lens Center H
Lens Center V
Lens R Flare
Lens G Flare
Lens B Flare
Lens W-R Offset
Lens W-B Offset
L R/G/B H Saw
L R/G/B H Para
L R/G/B V Saw
L R/G/B V Para
3
To execute the save, select "Execute,"
then press the SEL/SET button or jog
dial.
To cancel the save, select "Cancel," then
press the SEL/SET button or jog dial.
If you select "Execute," a list box of lens file
number appears. File numbers where "No
File" is displayed are empty file numbers.
4
Select the file number under which you
want to save the data, then press the
SEL/SET button or jog dial.
A confirmation message appears.
5
To execute the save, select "Execute,"
then press the SEL/SET button or jog
dial.
To cancel the save, select "Cancel," then
press the SEL/SET button or jog dial.
If you selected "Store SxS" in step 2, the
ACCESS lamp lights in red when you
execute the save.
When the data has been saved to the SxS
memory card, a completion message appears
and the ACCESS lamp goes out, or lights in
green.
Loading Lens Files
Insert an SxS memory card into a memory card
slot, or connect a USB memory to the USB
connector (type A), then proceed as follows.
See "Basic Menu Operations" (page 79) for details
on menu operations.
1
Select "LENS File" in the setup menu.
2
Select "Recall Mem," "Recall SxS," or
"Recall USB" by using the joystick or
the jog dial, then press the SEL/SET
button or jog dial.
Select "Recall Mem" if you want to load the
file from the camcorder's internal memory,
select "Recall SxS" if you want to load the
file from an SxS memory card, or select
"Recall USB" if you want to load the file
from a USB memory.