Saving And Loading Lens Files; Setting Lens File Data; Saving Lens Files; Loading Lens Files - Sony PMW-400K Operating Instructions Manual

Saving and Loading
Lens Files

Setting Lens File Data

Set the data in lens files on "FILE" > "Lens" in
the setup menu (see page 146).
You can set the following data and save it as a
lens file.
Setting data
V modulation shading
compensation values
Center marker position
Flare level
White balance
compensation value
White shading
compensation value
See "Basic Setup Menu Operations" (page 104) for
information about menu operations.

Saving Lens Files

Insert an SxS memory card into a memory card
slot, then proceed as follows.
See "Basic Setup Menu Operations" (page 104) for
information about menu operations.
1
Select "FILE" > "Lens" in the setup
menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see "To assign names to files"
(page 154).
156

Saving and Loading Lens Files

Sub-items
M V Modulation
Lens Center H
Lens Center V
Lens R Flare
Lens G Flare
Lens B Flare
Lens W-R Offset
Lens W-B Offset
L R/G/B H Saw
L R/G/B H Para
L R/G/B V Saw
L R/G/B V Para
2
Select "Lens Store Mem" or "Lens
Store SxS," and press the MENU knob.
Select "Lens Store Mem" if you want to save
the data in the camcorder's internal memory,
and select "Lens Store SxS" if you want to
save the data on an SxS memory card.
3
To execute the save, select "Execute,"
and then press the MENU knob.
To cancel the save, select "Cancel," and
then press the MENU knob.
If you select "Execute," a list box of lens file
number appears. File numbers where "No
File" is displayed are empty file numbers.
4
Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5
To execute the save, select "Execute,"
and then press the MENU knob.
To cancel the save, select "Cancel," and
then press the MENU knob.
If you selected Lens Store SxS in step 2, the
ACCESS lamp lights when you execute the
save (in blue on the right-side panel and in
orange in the card slot section).
When the data has been saved to the SxS
memory card, a completion message appears
and the ACCESS lamp goes out.

Loading Lens Files

Insert an SxS memory card into a memory card
slot, then proceed as follows.
See "Basic Setup Menu Operations" (page 104) for
information about menu operations.
1
Select "FILE" > "Lens" in the setup
menu.
2
Select "Lens Recall Mem" or "Lens
Recall SxS," and press the MENU knob.
Select "Lens Recall Mem" if you want to
load the file from the camcorder's internal
memory, and select "Lens Recall SxS" if you
want to load the file from an SxS memory
card.