Saving And Loading Lens Files; Setting Lens File Data; Saving Lens Files; Loading Lens Files - Sony PMW-350K Operating Instructions Manual

Saving and Loading
Lens Files

Setting Lens File Data

Use FILE >Lens (see page 139) in the setup menu
to set the data in lens files.
You can set the following data and save it as a
lens file.
Setting data
V modulation shading
compensation values
Center marker position
Flare level
White balance
compensation value
White shading
compensation value
See "Basic Setup Menu Operations" (page 97) for
information about menu operations.

Saving Lens Files

To save a lens file to an SxS memory card, insert
the card into a memory card slot and then proceed
as follows.
See "Basic Setup Menu Operations" (page 97) for
information about menu operations.
1
Select FILE >Lens in the setup menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see "To assign names to files"
(page 146).
148

Saving and Loading Lens Files

Sub-items
M V Modulation
Lens Center H
Lens Center V
Lens R Flare
Lens G Flare
Lens B Flare
Lens W-R Offset
Lens W-B Offset
L R/G/B H Saw
L R/G/B H Para
L R/G/B V Saw
L R/G/B V Para
2
Select Lens Store Mem or Lens Store
SxS, and press the MENU knob.
Select Lens Store Mem if you want to save
the data in the camcorder's internal memory,
and select Lens Store SxS if you want to save
the data on an SxS memory card.
3
To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you select [Execute], a list box of lens file
number appears. File numbers where "No
File" is displayed are empty file numbers.
4
Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5
To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you selected Lens Store SxS in step 2, the
ACCESS lamp lights when you execute the
save (in blue on the right-side panel and in
orange in the card slot section).
When the data has been saved to the SxS
memory card, a completion message appears
and the ACCESS lamp goes out.

Loading Lens Files

To load a lens file from an SxS memory card,
insert the SxS memory card into a memory card
slot, and then proceed as follows.
See "Basic Setup Menu Operations" (page 97) for
information about menu operations.
1
Select FILE >Lens in the setup menu.
2
Select Lens Recall Mem or Lens Recall
SxS, and press the MENU knob.
Select Lens Recall Mem if you want to load
the file from the camcorder's internal
memory, and select Lens Recall SxS if you
want to load the file from an SxS memory
card.
3
To execute the load, select [Execute],
and then press the MENU knob.