Side Terminal - JVC LST0904-001B Instruction Manual

Introduction
Names of Parts (continued)

Side Terminal

A
B
C
D
E
F
A
[HD/SD-SDI] HD/SD-SDI Output Terminal (BNC)
(A Page 114)
B
[Y/VIDEO] Y/Composite Video Signal Output
Terminal (BNC) (A Page 114)
C
[PB] PB Video Signal Output Terminal (BNC)
(A Page 114)
D
[PR] PR Video Signal Output Terminal (BNC)
(A Page 114)
E
[REMOTE] Remote Terminal (A Page 119)
F
[DC INPUT] DC Input Terminal (A Page 21)
Input terminal for DC 12 V power supply. Connects with an
AC adapter.
G
[AUDIO OUTPUT] Audio Output Terminal (RCA)
Output terminal for audio signals.
● Input audio signals are output during Camera mode.
● Playback audio signals are output during Media mode.
● Audio from input audio signals is output during HD/DV
signal (IEEE1394) input.
Memo:
● Alarm tone is not output.
H
[HD/DV] IEEE1394 Terminal Mode Switch
(A Page 115)
I
[INT/EXT] IEEE1394 Interface Terminal Switch
(A Page 115)
For selecting a valid IEEE1394 interface terminal.
[EXT] : Enables IEEE1394 signals from the [IEEE1394]
terminal M.
: Enables the accessory connector B at the rear
[INT]
of the camera recorder. (A Page 13)
J K
G HI
J
Shoulder Pad Slide Button
For adjusting the shoulder pad position. Press this button to
adjust the shoulder pad K position to the front or back.
K
Shoulder Pad
L
[USB] USB Terminal (A Page 118)
M
[IEEE1394] IEEE1394 Terminal (4-pin)
For connecting digital video equipment with IEEE1394
terminal using an IEEE1394 cable (sold separately).
To enable this terminal, set the [INT/EXT] IEEE1394 terminal
switch I to [EXT].
(A Page 115 [IEEE1394 Connection])
(A Page 117 [Stream Transmission to a Non-linear Editing
System])
M
Note:
● When connecting IEEE1394 cables, check that the
L
connectors are facing the right direction before you insert.
Memo:
● Put on the covers when the connectors are not in use.