Operation Mode - JVC LST0904-001B Instruction Manual

Operation Mode

This camera recorder has three operation modes - Camera mode, Media mode, and USB mode.
The operation mode indicator on the left side of the camera recorder lights up according to the mode.
Camera Mode
Camera Mode
[CAM/MEDIA]
Selection
Button
Connection
disabled on PC
Operation
Operation Mode Mode
Indicator
Camera Mode Blue
Purple
Media SD Card Green
Mode Mode
IEEE1394 Orange
Mode
USB Mode Orange
[CAM/MEDIA] Selection Button
[CAM/MEDIA] Selection
Button
Playback
Thumbnail
Button
Display
Stop Button
USB Connection (when the confirmation to change
to USB mode appears and [Change] is selected)
USB Mode
(USB mass storage class)
This is the camera shooting mode. The camera recorder starts up in Camera mode when the power is turned on.
Memo:
● Images recorded on the SDHC card cannot be played back in this mode. However, you can check (play
back) the most recently recorded image using the Clip Review function. (A Page 52)
When [Rec Mode] is set to Variable Frame , the operation mode indicator lights up in purple during Variable
Frame REC in Camera mode. (A Page 56)
This mode allows you to play back or delete clips recorded on the SDHC card.
Press the [CAM/MEDIA] selection button to enter SD Card mode when you are not shooting in Camera mode.
Once the camera recorder is in SD Card mode, thumbnails of the selected media slot are displayed.
This is the input mode for video images from the IEEE1394-connected equipment.
The camera recorder enters IEEE1394 mode when you press the [CAM/MEDIA] selection button while the
power of the equipment connected to the [IEEE1394] terminal is turned on during thumbnail display in Media
mode (SD Card mode).
Once the camera recorder is in IEEE1394 mode, the playback images of the connected equipment are displayed.
However, if the IEEE1394 connection is not recognized (such as when the power of the IEEE1394-connected
equipment is not turned on), the camera recorder will switch to Camera mode instead.
Press the [CAM/MEDIA] selection button during IEEE1394 mode to switch to Camera mode.
If the power of the equipment connected to the [IEEE1394] terminal is OFF or if connection is canceled in
IEEE1394 mode, the camera recorder will not automatically switch to other modes. To quit IEEE1394 mode,
you must operate the [CAM/MEDIA] selection button.
Note:
● This mode is used for viewing images input to the [IEEE1394] terminal from an external device, and not
intended for recording input images on the camera recorder.
This mode allows you to connect to a PC and transfer the files on an SDHC card to the PC.
When the camera recorder is connected to a USB cable, the message Change to USB Mode appears.
Select [Change] and press the Set button (R) to switch to USB mode. (A Page 118)
In USB mode, the camera recorder is recognized by the connected PC as a peripheral drive (USB mass
storage class only). Disable the connection on the PC and remove the USB cable from the camera recorder to
switch to Camera mode. (A Page 118)
Memo:
● When a USB cable is connected, the message appears after recording stops.
● If playback is in progress, the message appears once the files are closed automatically, such as when
playback stops.
Media Mode
IEEE1394
Mode
SD Card Mode
Playback
(Playback/Pause/Fast Forward/
Rewind/Clip Jump)
Description
[CAM/MEDIA] Button
Operation Mode Indicator
Stop Button
Playback Button