Stream Transmission To A Non-Linear Editing System - JVC LST0904-001B Instruction Manual

Stream Transmission to a Non-linear
Editing System
Playback images on the camera recorder can be stream
output during editing using a non-linear editing system.
Loading to a Non-linear Editing System
in Play Mode
1
Perform the following settings on the camera
recorder.
A
Set the [HD/DV] IEEE1394 terminal mode switch to
DV .
B
Set the [INT/EXT] IEEE1394 interface terminal switch to
EXT .
Memo:
● Stream transmission is only possible for DV format
images.
2
Connect the IEEE1394 cable.
3
Turn on the power of both the camera recorder and
non-linear editing system.
4
Set the camera recorder to Media mode.
Press the [CAM/MEDIA] selection button to switch to Media
mode. (A Page 7)
[HD/DV] IEEE 1394
Terminal Mode
Switch
[INT/EXT] IEEE1394
Interface Terminal
Switch
IEEE1394
Cable
Note:
● Start recording only after ensuring that the devices are
properly connected.
5
Insert the media to be dubbed.
Camera recorder : Recorded SDHC card
6
Press the play button (center of the cross-shaped
button) on the camera recorder.
Playback starts.
[IEEE1394] Terminal
PC
Signal Flow
7
Start loading to the non-linear editing system.
For details, refer to the instruction manual of the non-linear
editing system.
8
Loading is complete.
After loading is complete, press the [CANCEL] button on the
camera recorder to stop playback.
Memo:
● Switch the [HD/DV] IEEE1394 terminal mode switch only
after turning OFF the power of the camera recorder.
● The operating procedures vary depending on the
characteristics and specifications of the connected
devices, and transfer of data may fail even when the
devices are properly connected.
● If noise appears on the screen or audio sound is
interrupted, reconnect the IEEE1394 cable or turn on the
power of the camera recorder again.
● Noise may occur in the audio when you turn ON/OFF the
power of the device connected to the [IEEE1394] terminal.
Before performing any of these operations, lower the
volume of the device connected to the camera recorder to
the minimum.