Toshiba e-STUDIO 16P Service Manual page 69

e-STUDIO 16P
Paper Picks but Stops Half Way Through the Printer ks but Stops Half Way Through the Printer
FRU
Input Paper Feed Sensor
Engine Board
Paper Never Picks
FRU
Paper Tray Tray
Pick Roller Solenoid
2-52
Service Manual
cks
Action
Make sure the input paper feed
sensor is working properly.
Check for a broken or stuck flag on
the input paper feed sensor.
Check to make sure the cable is
seated on the engine board. See
"Connector Locations" on
page 5-1 for more information.
• If correct, replace the input paper
feed sensor.
• If these voltages are not correct,
replace the engine board.
Action
Make sure the paper tray is correctly
installed. The black mylar guide
sheet in the front of the tray must be
positioned in the paper path just
behind the pick roller assembly. This
guide sheet can easily block the
paper path if installed incorrectly.
Make sure solenoid is installed
correctly and its cable is plugged into
the engine board. See
Locations" on page 5-1
information.
• If the voltage is present, replace
the solenoid.
• If the voltage is not present, see
the "Engine Board Service
Check" on page
"Connector
for more
2-41.