Toshiba e-STUDIO 16P Service Manual page 120

e-STUDIO 16P
Parallel Mode 1
Parallel Mode 1 controls whether or not resistors are enabled on the Mode 1 controls whether or not resistors are enabled on the
parallel post signals. The default is to not have the resistors enabled,
however, this function is useful because some IBM clone personal
computers have open collector outputs on their parallel port signals.
Perform the following steps to change the Parallel Mode 1 setting:
1. Enter the configuration mode. See
page 3-14
2. Perform a double click button press five times. This moves to
the Parallel Mode 1 item on the configuration menu. The Parallel
Mode 1 (Ready) LED is blinking.
3. The current Parallel Mode 1 setting is indicated by the
Off/On/Auto (Press Button) LED. When the LED is off, the
Parallel Mode 1 is set to off. When the LED is on, the Parallel
Mode 1 is set to on. Perform a brief button press to select the
Parallel Mode 1 setting.
4. Perform a long button press. All LEDs blink once, indicating the
setting is saved.
5. Exit the configuration mode by turning the printer power off.
Off/On/Auto
for more information.
ved.
Setting Value
Parallel mode 1 is set to off (resistors enabled).
Parallel mode 1 is set to on (resistors disabled).
See "Configuration Mode guration Mode" on
brief button press to select the
Diagnostic Aids
3-27