Toshiba e-STUDIO 16P Service Manual page 116

e-STUDIO 16P
Parallel Port
Parallel Port lets the user enable or disable the parallel port. If the
port is not being used, disabling it frees allocated memory to be
used to process print jobs.
Note: Parallel port options are not available to change in some
network models.
Perform the following steps to change the Parallel Port setting:
1. Enter the configuration mode. See
page 3-14
The Parallel Port (Ready) LED comes on solid. The current
Parallel Port setting is indicated by the Off/On/Auto (
Button) LED. When the LED is off, the parallel port is disabled.
When the LED is blinking, the parallel port is enabled.
2. Perform a brief button press to select the Parallel Port setting.
3. Perform a long button press. All LEDs blink once, indicating the
setting is saved.
4. Exit the configuration mode by turning the printer power off.
Off/On/Auto
for more information.
Setting Value
Parallel port is disabled. The printer doesn't receive port is disabled. The printer doesn't receive
data from the parallel port.
Parallel port is enabled with a fixed buffer size. The
buffer size is set from a utility such as MarkVision.
Note: This LED state is only displayed if the current
value for the Parallel Port Enabled setting is a fixed
value. The user can't set the value by pressing the
button to cycle from the off value to the on value,
that is, the button press cycles from off to auto.
Parallel port is enabled with an automatic buffer
size. The printer determines the buffer size based
on available memory and other printer settings.
See "Configuration Mode
Off/On/Auto (Press
Diagnostic Aids
de" on
3-23
c Aids