Toshiba e-STUDIO 16P Service Manual page 119

e-STUDIO 16P
Parallel Protocol
The printer supports two parallel protocol settings: Standard and
Fastbytes. When the protocol is set to Standard, information is
received at a normal transmission rate. When the protocol is set to ved at a normal transmission rate. When the protocol is set to
Fastbytes, information is received at a much faster transmission rate
provided the host computer supports the Fastbytes mode.
Perform the following steps to change the Parallel Protocol setting:
1. Enter the configuration mode. See
page 3-14
2. Perform a double click button press two times. This moves to
the Parallel Protocol item on the configuration menu. The
Parallel Protocol (Load Paper) LED comes on solid.
3. The current Parallel Protocol setting is indicated by the
Off/On/Auto ( /On/Auto (Press Button) LED. When the LED is off, the
Parallel Protocol is set to Standard. When the LED is on, the
Parallel Protocol is set to Fastbytes. Perform a brief button press
to select the Parallel Protocol setting.
4. Perform a long button press. All LEDs blink once, indicating the
setting is saved.
5. Exit the configuration mode by turning the printer power off.
Off/On/Auto
3-26
Service Manual Manual
14 for more information.
ved.
Setting Value
Parallel port uses Standard protocol.
Parallel port uses Fastbytes protocol.
See "Configuration Mode" on
LED comes on solid.
bytes. Perform a brief button press