Replacing Small Parts (User-Replaceable); Table 2-6. Replacing Small Parts (User-Replaceable) - HP OmniBook 4100 Service Manual

3. Reboot the computer. If you are using the Recovery CD, press ESC during reboot to cancel the
OmniBook screen, ESC to display the boot-device menu, then select the CD-ROM drive as the
boot device.
4. When prompted, select "Create Hibernate Partition."
We recommend that you create a 96-MB partition, the same as the factory setup.
Replacing Small Parts
(User-Replaceable)
The following small parts are user-replaceable.
Part
Docking Doors
Feet
I/O Door
Pointing Stick Cap
RAM/BIOS Cover
VGA Connector Cover
HP OmniBook 4100

Table 2-6. Replacing Small Parts (User-Replaceable)

Replacement Procedure
Open each door and flex the door until one side tab releases. To replace, see the
picture on page 2-19.
Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly
press the adhesive side of the foot into the recess.
With the door closed, insert a small flat-blade screwdriver behind the door from
below. Flex the door until one side tab releases. It helps to press in lightly on the
ends of the door.
Pull the cap off the pointing stick.
On the bottom of the unit, remove the two screws from the RAM/BIOS cover and
remove the cover.
With the display closed, push up on the cover and down on the bottom case until the
lower tabs release. To install, insert the top tabs into the strip cover, then push up on
the cover and down on the bottom case until you can insert the lower tabs.
Removal and Replacement 2-7