4. When prompted, select "Create Hibernate Partition."
OmniBook 2100/3100: We recommend that you create a 96-MB partition, the same as the factory
setup.
OmniBook 3000: We recommend that you create a 144-MB partition, the same as the factory
setup.
Removing a RAM Board
(User-Replaceable)
Description
RAM board, 16-MB SODIMM
RAM board, 32-MB SODIMM
RAM board, 64-MB SODIMM
Caution
Handle the RAM board only by its edges and provide proper grounding. Otherwise, you may
damage the board due to electrostatic discharge.
Required Equipment
• Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the hard disk drive (see page 2-5).
3. Slide open the RAM cover about 3 mm, then lift off the cover.
4. Release the two metal latches at the sides of the RAM board, so the free edge of the board pops
up.
5. Pull the board out of the connector.
HP OmniBook 2100/3000/3100
Table 2-5. RAM Board Replacement Part Numbers
Part Number
F1363-60001
F1364-60001
F1365-60001
Figure 2-5. Removing the RAM Cover
Exchange
Part Number
2100
•
F1363-69001
•
F1364-69001
•
F1365-69001
RAM Cover
Removal and Replacement
OmniBook
3100
3000
•
•
•
•
•
•
2-7