Mac Clone; Lan - TP-Link TD-W8960N User Manual

TD-W8960N
4.4.2.7 ETH-IPoE
If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to IPoE
over ATM interface (see section
4.4.2.8 ETH-Bridge
If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-7 and the next configuration is similar to Bridge
over ATM interface (see section
4.4.3

MAC Clone

Choose menu "Advanced Setup""MAC Clone", you can configure the MAC address of the
WAN Interface as shown below.
The WAN Interface List displays the Lay2 Interfaces you have configured on the section
Layer2 Interface and its default MAC Address. If you have not configured corresponding WAN
Service for the interface on the section
"Need a corresponding WAN Service".
The last one of WAN Interface List displays your PC's current address.
Type the new value for the WAN Interface who's MAC Address you want to change.
You can select corresponding WAN Interface from the drop-down list and click Clone button to
clone your current PC MAC.
Click Restore Default button to restore the WAN Interface's default MAC Address.

Note:
Only the WAN Ports can use MAC Address Clone function. All the clone MAC addresses must not
be the same with each other.
4.4.4

LAN

Choose "Advanced Setup""LAN", and you will see the LAN screen (shown in Figure 4-21), the
section allows you to configure the router's LAN ports settings.
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
4.4.1.2 ETH
4.4.2.2 ATM-EoA-IPoE).
4.4.1.2 ETH
4.4.2.3 ATM-EoA-Bridg).
4.4.2 WAN
Figure 4-20
27
Interface.
Interface.
Service, the blank for MAC Address will display
4.4.1