The Back Panel - TP-Link TD-W8960N User Manual

TD-W8960N
(LAN1-4)
 Note:
1. If the ADSL LED is off, please check your Internet connection first. Refer to
the Modem Router
you have already made a right connection, please contact your
Internet service is available now.
2. If the Internet LED is off, please check your ADSL LED first. If your ADSL LED is also off,
please refer to Note
configuration. You may need to check this part of information with your ISP and make sure
everything have been input correctly. Refer to
1.3.2

The Back Panel

 ADSL: Connect to the Modem Port of Splitter or to the telephone line.
 LAN1, LAN2, LAN3, LAN4/WAN: Through these ports, you can connect the router to your PC
or the other Ethernet network devices. Enable EWAN function and you will be able to connect
to Cable/FTTH/VDSL/ADSL device.
 USB: The USB port connects to a USB storage device or a USB printer.
 WiFi: The switch for the WiFi function.
 RESET: There are two ways to reset the router's factory defaults.
300Mbps Wireless N USB ADSL2+ Modem Router User Guide
No storage device or printer is plugged into the USB port.
Off
On
There is a device connected to this LAN port.
The modem router is sending or receiving data over this LAN
Flash
port.
Off
There is no device connected to this LAN port.
for more information about how to make Internet connection correctly. If
1. If your ADSL LED is GREEN ON, please check your Internet
Figure 1-2
4.2 Device Info for more information.
5
2.3 Connecting
ISP to make sure if your