Fiat Panda Owner's Handbook Manual page 160

❒ make sure that the compressor switch A fig. 118 is
in position 0 (off), start the engine, plug into the
GETTING TO KNOW
power socket in the central tunnel fig. 119 and
YOUR CAR
operate the compressor turning switch A to
position I (on). Inflate the tyre to the pressure
specified in the "Inflation pressure" paragraph in
SAFETY
the "Technical specifications" section. Check tyre
pressure on gauge B fig. 118 with compressor
off to obtain a more precise reading;
❒ if after five minutes it is still impossible to reach at
STARTING AND
least 1.8 bar, disengage the compressor from the
DRIVING
valve and power socket, then move the car
forwards by approx. ten metres in order
to distribute the sealing fluid inside the tyre evenly,
WARNING LIGHTS
then repeat the inflation operation;
AND MESSAGES
❒ if after this operation you still cannot reach at least
1.8 bar after 5 minutes from switching on the
compressor, do not resume driving but contact a
IN AN
Fiat Dealership;
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
fig. 118
156
Apply the adhesive label where it can be
easily seen by the driver as a reminder
that the tyre has been treated with the quick
repair kit. Drive carefully, particularly on bends.
Do not exceed 80 km/h. Do not accelerate or
brake suddenly.
❒ after driving for about 10 minutes stop and check
the tyre pressure again; pull up the handbrake;
For the safety of the car when it is parked, follow
the indication in the paragraph "When parked"
in the chapter "Starting up and driving" .
fig. 119
F0W0181
WARNING
F0W0178