Draytek Vigor 2110 User Manual page 155

2. The configuration page will be shown as follows:
Available settings are explained as follows:
Item
Name
Address Type
MAC Address
Start IP Address
End IP Address
Prefix Len
Invert Selection
3. After finishing all the settings here, please click OK to save the configuration.
Vigor2110 Series User's Guide
Description
Type a name for this profile. Maximum 15 characters are
allowed.
Determine the address type for the IPv6 address.
Select Single Address if this object contains one IPv6
address only.
Select Range Address if this object contains several IPv6s
within a range.
Select Subnet Address if this object contains one subnet for
IPv6 address.
Select Any Address if this object contains any IPv6 address.
Select Mac Address if this object contains Mac address.
Type the MAC address of the network card which will be
controlled.
Type the start IP address for Single Address type.
Type the end IP address if the Range Address type is
selected.
Type the fixed value for prefix length.
If it is checked, all the IPv6 addresses except the ones listed
above will be applied later while it is chosen.
147