Cth2-Series Assembly Overview; Major Component Descriptions - Roberts Gorden CTH2 Series Installation, Operation And Service Manual

ROBERTS GORDON ® CTH2-Series S

CTH2-Series ASSEMBLY OVERVIEW

Major Component Descriptions

Burner with Tube Gasket
Burner Tube
Supplied in 10
'
(3 m) lengths. Burner
tube is always the first tube
after the burner.
Tube and Reflector Hanger
with Clamp Package
Position this hanger no more
than 4" (10 cm) away from
the burner.
Tube and Reflector Hanger
Suspend system from these
hangers.
Reflector Support Strap &
Wire Form
Flex Gas Line with
Shut Off Cock
© 2004 Roberts-Gordon
S
UBMITTAL HEET
Must be installed with the
flame observation
window facing down.
APPLICATIONS, ENGINEERING AND DETAILED GUIDANCE ON SYSTEMS DESIGN, INSTALLATION AND PRODUCT PERFORMANCE IS AVAILABLE UPON REQUEST. ROBERTS GORDON
INSTALLED ONLY IN ACCORDANCE WITH LOCAL LAWS, CODES AND REGULATIONS, AND ONLY BY A CONTRACTOR QUALIFIED IN THE INSTALLATION AND SERVICE OF GAS-FIRED HEATING EQUIPMENT.
Reflector
(Aluminum or
Stainless
Steel)
Alternate overlap as
shown on overview.
Minimum overlap is
7" (18 cm).
Tube
Hot Rolled or Heat
Treated Aluminized Tube
Supplied in 10' (3 m) lengths.
Vent Adapter
Turbulator must
be installed in the last
standard section of tube.
Turbulator is not required on the
CTH2-125/150/175.
Coupling Assembly
with Lock
Reflector End Cap
Punch out center
section to
accommodate heat
exchanger tube.
Turbulator
® PRODUCTS ARE TO BE