Frame Shield Installation; Reflector Side Extension Installation - Roberts Gorden CTH2 Series Installation, Operation And Service Manual

ROBERTS GORDON ® CTH2-Series S

Frame Shield Installation

Shield

Reflector Side Extension Installation

NOTE: If the Decorative Grille system is to
be installed in an area with considerable
air movement, it is recommended that one
#8 x 3/8 (3.9 x 9.5mm) sheet metal screw
be installed per reflector extension to
prevent it from blowing over.
Distance "A"
Minimum Maximum
2" (4 cm) 6" (15 cm)
6" (15 cm) 10" (26 cm)
10" (26 cm) 14" (37 cm)
© 2004 Roberts-Gordon
S
UBMITTAL HEET
A
Extension
Part No. Width
01370408 8" (20 cm)
01370412 12" (30 cm)
01370416 16" (40 cm)
APPLICATIONS, ENGINEERING AND DETAILED GUIDANCE ON SYSTEMS DESIGN, INSTALLATION AND PRODUCT PERFORMANCE IS AVAILABLE UPON REQUEST. ROBERTS GORDON
INSTALLED ONLY IN ACCORDANCE WITH LOCAL LAWS, CODES AND REGULATIONS, AND ONLY BY A CONTRACTOR QUALIFIED IN THE INSTALLATION AND SERVICE OF GAS-FIRED HEATING EQUIPMENT.
Description
Deco Grille Shield
Cut Relief Notches for Tube
and Reflector Hangers
Reflector Side
Extension
Description
Reflector Side Extension
Part Number
01365900
Insert Screw
here
Part Number
01370412
® PRODUCTS ARE TO BE