Advertisement
3.0 IMPORTANT SAFETY FEATURE:
You can set a private code into your system to prevent accidental operation by another transmitter nearby.
Figure10
Acumen
FCC ID:EPK10305
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL
INTERFERENCE AND
MUST ACCEPT ANY INTERFERENCE
INCLUDING
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
IC:2887A-10305
Model No.: WMT103
3.1 Coding Instructions:
1 There are code switches at the back of the Remote Wall Mount. Slide the code switches to you choice of
ON or OFF positions. FACTORY SETTING IS ALL 'OFF'.
2 Make sure the slide switch on the Remote Receiver is at the OFF position.
3 Take the Remote Wall Mount close to the GAS Fireplace, AGP Pellet Stove or GAS Insert or the Remote
Receiver (less than 2-10 feet from the GAS Fireplace, AGP Pellet Stove or GAS Insert or Remote
Receiver is recommended.)
4 Slide the slide switch on the Remote Receiver to REMOTE position.
5 Install fresh AAA alkaline batteries into the Remote Wall Mount.
6 Press any button on the Remote Wall Mount. The Remote Receiver will produce a 'beep' sound when it
receives the code from the Remote Wall Mount. The system is now ready to operate.
7 If you do not hear a 'beep' sound from the Remote Receiver, removes batteries from the Remote Wall
Mount and slide the slide switch on the remote receiver to OFF position, wait for 1 minute, and repeat
step 3 to 6.
8 If you desire to operate multiple Remote Receivers with the one Remote Wall Mount, continue to hold the
button on the Remote Wall Mount as you bring the Remote Wall Mount within 5 feet of each Remote
Receiver then slide the slide switch on the Remote Receivers to the REMOTE position. Each will
acknowledge receipt of coding with a beep.
Figure 11
ON
1
2
3
4
5
6
Select Code
Position
Note: User must repeat SET PRIVATE CODE every time they change the code.
See Figure 10.
(2) THIS DEVICE
RECEIVED,
see figure 11
Install 4AA Batteries
Page 5 of 6
C-P
ON
DIP
1 2 3 4 5 6
BAT.LOW
OFF REMOTE ON
Switch Receiver
to Remote
BAT.LOW
OFF REMOTE ON
Switch off
the Receiver
Install 3AAA Batteries
Advertisement
