Advertisement
Thermostat Wall Wireless AGP Pellet Stove
GAS Fireplace, Pellet or GAS Insert Only
GAS Fireplace, AGP Pellet Stove or GAS Insert Remote Control Operating Instructions For The Homeowner
BEFORE YOU BEGIN:
Warning
Read all of the safety precautions in the owner's manual included with your GAS Fireplace,
AGP Pellet Stove or GAS Insert before using this remote control. The thermostat is not
intended for unattended use.
1.0 INSTALLING FRESH BATTERIES:
Note: It is not necessary to re-set your private code when Installing Fresh Batteries. The GAS
Fireplace, AGP Pellet Stove or GAS Insert MUST be OFF before replacing transmitter batteries .
1.1 RECEIVER CHANGING BATTERIES: see
1
The Remote Receiver uses 4 pieces AA-size batteries. Slide the slide switch at the Remote Receiver to
the Off position.
2
Press the battery compartment slightly into the Remote Receiver and then release.
compartment will pop out of the Remote Receiver.
3
Slide open the battery door and replace batteries.
4
Replace the battery door and slide the battery compartment back into the Remote Receiver.
Press and then Release
1.2 WALL MOUNT CHANGING BATTERIES: see
1
The Remote WALL MOUNT uses 3 AAA-size batteries. Replace these batteries at least every 6 months
or when the Low battery indicator on the LCD is on.
2
Press the battery compartment slightly into the Remote WALL MOUNT and then release. The battery
compartment will pop out of the Remote WALL MOUNT.
3
Slide open the battery door and replace batteries.
4
Replace the battery door and slide the battery compartment back into the Remote WALL MOUNT.
5
After you take out the batteries, wait for at least 1 minute before putting fresh batteries into the Remote
WALL MOUNT and Receiver.
6
Use fresh alkaline batteries only.
AM
TIMER
ROOM TEMP
SET TEMP
F
Press and then Release
99300687
Slide open the battery door
Fresh Alkaline
AAA Batteries.
(BATTERY COMPARTMENT)
Page 1 of 6
Figure 1
Fresh Alkaline
AA Batteries.
Figure 1
Figure 2
Figure 2
The battery
Advertisement
